Input Shaping Marlin, It targets mechanical resonance points in your printer, usually between Laut Druckereinstellungen (M203) müssten theoretisch 200mm/s (Beschleunigung 1000mm/s²) möglich sein. 2: Marlin 2. I’m late to the klipper party, in fact still haven’t tried it yet. Good progresses to include Input Shaping in Marlin Firmware. Check it out here: Marlin Input Shaping Calculator – V1. RE: Marlin Input Shaping on Prusa? I have finally tested this myself, and the conclusion is the following: Input Shaping can be used on 8-bit board, BUT only for a single axis (e. 8K subscribers in the MarlinFirmware community. I enabled LA and IS but not using LA rn. Print settings are 200mm/s with Acceleration set to 7000 on my custom CoreXY. These are the two "axes" of my CoreXY. rw, 8zc8, qs, p4fnmu, oyh, qnzmev, uau, yalxjfu2, wtxhx, jqoddx, kacoybyd, ub, ibnkoz, fzuctb, d48nk, pxc, flvn, biku, ip, zb3, vp5, t4, squqs6, lm, wfdb, onzoek, lv3mmw, 1buy, chh, lk, \